IBM Mainframe Forum

Hi,
I tried to run a job with a cycle control(VSAM file) and received the following error:

VSAM STATUS CODE = 47
CEE3250C The system or user abend U4005 R=NULL was issued.
From compile unit M626758A at entry point CYCLECTL at compile unit offs
at address 00134E60.

Also, I saw this in the "Message" section:

IEC130I CYCLFILE DD STATEMENT MISSING
IEA995I SYMPTOM DUMP OUTPUT
USER COMPLETION CODE=4039 REASON CODE=00000000
TIME=10.02.45 SEQ=39237 CPU=0000 ASID=0242
PSW AT TIME OF ERROR 078D1000 B06B176E ILC 2 INTC 0D
ACTIVE LOAD MODULE ADDRESS=305F1980 OFFSET=000BFDEE
NAME=CEEPLPKA
DATA AT PSW 306B1768 - 00181610 0A0D58D0 D00498EC
AR/GR 0: A7996EDE/84000000 1: 00000000/84000FC7
2: 00000000/0017DE78 3: 00000000/0002000D
4: 00000000/306A5E40 5: 00000000/0017DA0C
6: 00000000/00000000 7: 00000000/305EF2A8
8: 00000000/0017DE78 9: 00000000/0017F57E
A: 00000000/0017DA0C B: 00000000/306B1698
C: 00000000/00162B58 D: 00000000/00180678
E: 00000000/B06A4F2C F: 00000000/00000000
END OF SYMPTOM DUMP

When I searched the web on the VSAM Status Code 47, I found the following:
"READING FILE NOT OPEN AS INPUT/IO/EXTEND"

But I have been using the VSAM file before without any problem....
Any advice would be very much appreciated.
Thank you!!!

Hello,

IEC130I CYCLFILE DD STATEMENT MISSING

It appears that your jcl is missing at least this. . .