IBM Mainframe Forum

Dear Support,
I have a question for SDSF Max-RC field.
I try a JCL with TYPRUN=SCAN, then JCL is DUMMY JOB(for IEFBR14).
In z/OS v1.4 and v1.8 , then TYPRUN=SCAN JCL completed and SDSF MAX-RC field is blank.
But in z/OS v1.11, I find TYPRUN=SCAN completed and SDSF MAX-RC field is CC-0000.
.
Please kindly give me some suggestion for this situation. thanks.
z/OS V1.8
SDSF OUTPUT ALL CLASSES ALL FORMS
JOBNAME Max-RC
ZTWSDUMY ------> this is blank
.
z/OS V1.11
SDSF OUTPUT ALL CLASSES ALL FORMS
JOBNAME Max-RC
ZTWSDUMY CC-0000 ------> this is 0000
--------------------------------------------------------
Whar reason occur this problem? thanks.
.
Stan Yang

This is not a problem -- it is a change in system behavior, which happens every release of z/OS. YOU may have an issue with it, but IBM probably told you all about the change in the manual. I recommend you read the SDSF manual and verify this. Once it has been verified, be aware that there may be no way to change the behavior -- IBM made the change for a good reason so they are not likely to undo the change just because you don't like it.

RTFM.

Dear support:
Thanks many again.
It is fine for your response. and I will to read SDSF paper. thanks.
I think I need to find what release version for z/OS change this behavior. thanks.
.
Stan Yang.

Dear All:
Have any one know what release for JES2 or SDSF version to change this situation?
or have any JES2 parameter to control this situation?
that is have any parameter to reset to ori situation?
I try to check JES2 manual and SDSF manual , but it is Not find any message.
Please give me some suggestion or advise. Thanks.
Stan.