IBM Mainframe Forum

Hi,

I just need to know how we can set "caps on " through entire mainframe session.

EDIT TCA07T15.NDM.JCLLIB(T6BKBLP6) - 01.59 Columns 00001 00072
Command ===> Scroll ===> CSR
****** ***************************** Top of Data ******************************
=PROF> ....JCLLIB (FIXED - 80)....RECOVERY ON....NUMBER OFF....................
=PROF> ....CAPS ON....HEX OFF....NULLS ON STD....TABS OFF.....................
=PROF> ....AUTOSAVE ON....AUTONUM OFF....AUTOLIST OFF....STATS ON..............
=PROF> ....PROFILE UNLOCK....IMACRO NONE....PACK OFF....NOTE ON................
=PROF> ....HILITE JCL CURSOR FIND..............................................

if above i am giving caps on command then its applicable to that member only. suppose i am opening some other member in same session as showm below :-

EDIT TCA07T15.NDM.JCLLIB(T6BKBLP7) - 01.51 Columns 00001 00072
Command ===> Scroll ===> CSR
****** ***************************** Top of Data ******************************
=PROF> ....JCLLIB (FIXED - 80)....RECOVERY ON....NUMBER OFF....................
=PROF> ....CAPS OFF....HEX OFF....NULLS ON STD....TABS OFF.....................
=PROF> ....AUTOSAVE ON....AUTONUM OFF....AUTOLIST OFF....STATS ON..............
=PROF> ....PROFILE UNLOCK....IMACRO NONE....PACK OFF....NOTE ON................
=PROF> ....HILITE JCL CURSOR FIND..............................................

Then CAPS OFF is coming so is there any command to do that ?

CAPS ON or OFF is applied to the whole library until you come to a member that has lower case characters. If you want to have CAPS ON permanently then make sure all your data in that library is all in upper case.

Use CAPS as "Initial Macro" or create an initial macro that actually checks that you are editing JCL and only sets CAPS ON if you do...