IBM Mainframe Forum

Hi Frds,

did any body know what the UDS2000 utility program used for.

let me know your comments.

I think it is used for setting user defined default specifications to the prevailing GDDM values.

Hello and welcome to the forum,

Where did you hear of this utility?

Did you ask whoever supports the job where it is run?

Must be important. I've seen this question posted on at least three different forums.

Your question is site specific. Unless, for the purpose I'd been using UDS2000 at my shop -- my answer would be useless. Suggest, you look into the documentation of the PROC(s) in which this program is called.

Just for a note -- usually, in a crude sense, whenever there is a need of balancing between interfacing systems this program is used under the heading "UNITECH AUTOMATED CONTROL". So it's a program used for Unitech Procedures. It's a copyright material if you need further information get in touch with Unitech Support people at your shop or the people who support this there.

Hope this helps.