IBM Mainframe Forum

by **LasseH** » Fri Dec 11, 2020 1:42 am

Hi all
Trying to use some nice symbolic parms in jcl but found out that it seems that IBM has SYSSYM=DISALLOW as default for jobclasses but not for STCs
Does anyone know for what reasons, and do You see any problems with changing that to ALLOW?

Select all

JOBCLASS(STC)       AUTH=(ALL),BLP=NO,COMMAND=EXECUTE,  
                     CONDPURG=NO,DSENQSHR=ALLOW,         
                     IEFUJP=YES,IEFUSO=YES,              
                     JESLOG=(NOSPIN),LOG=YES,            
                     MSGLEVEL=(1,1),MSGCLASS=X,          
                     OUTDISP=(HOLD,HOLD),OUTPUT=YES,     
                     PERFORM=000,PROMO_RATE=0,           
                     PROCLIB=00,QAFF=(ANY),REGION=0000K, 
                     SWA=ABOVE,TIME=(001440,00),         
                     TYPE26=YES,TYPE6=YES,DESC= 

JOBCLASS(A)         ACTIVE=YES,ACCT=NO,AUTH=(ALL),     
                     BLP=NO,COMMAND=VERIFY,COPY=NO,     
                     DSENQSHR=ALLOW,DUPL_JOB=DELAY,     
                     GDGBIAS=JOB,GROUP=,HOLD=NO,        
                     IEFUJP=YES,IEFUSO=YES,             
                     JESLOG=(NOSPIN),JOBRC=MAXRC,       
                     JOURNAL=YES,LOG=YES,MODE=JES,      
                     MSGLEVEL=(1,1),OUTDISP=(,),        
                     OUTPUT=YES,PERFORM=000,            
                     PROMO_RATE=0,PGMRNAME=NO,          
                     PROCLIB=00,QAFF=(ANY),QHELD=NO,    
                     RESTART=NO,REGION=0004M,SCAN=NO,   
                     SCHENV=,SWA=ABOVE,SYSSYM=DISALLOW,   <====
                     TIME=(001440,00),TYPE26=YES,       
                     TYPE6=YES,XBM=,XEQCOUNT=(MAXIMUM=*,
                     CURRENT=3),                        
                     XEQMEMBER(SYSP)=(MAXIMUM=*,        
                     CURRENT=3),DESC=                   
         
 

//Lasse

by **sergeyken** » Fri Dec 11, 2020 1:48 am

Only the System Programmer at your company can help with this issue.

by **willy jensen** » Fri Dec 11, 2020 2:09 pm

IBM in general is careful to change defaults. I have worked where ALLOW was set for all in jobclasses, with no ill effect. But you still must read the doc careful.

by **taltyman** » Fri Dec 18, 2020 1:30 am

It can be dynamically changed. So change a little used class and test. If all goes well then you can expand which classes are allowed.

by **enrico-sorichetti** » Fri Dec 18, 2020 7:59 pm

It can be dynamically changed. So change a little used class and test.

only if You have the proper authority :ugeek:

IBM Mainframe Forum

Symbolic parms in JCL

Symbolic parms in JCL

Re: Symbolic parms in JCL

Re: Symbolic parms in JCL

Re: Symbolic parms in JCL

Re: Symbolic parms in JCL