Hi,
I created a debug profile using CADP like here:
https://www.ibm.com/support/knowledgece ... fha7qg.htm
I already activeted the profile, but I forgot the cics command to execute it.
Could you tell me the steps to execute or point me to links?
Thank you!
How to execute a debug profile
Previous topic • Next topic • 4 posts
• Page 1 of 1
Re: How to execute a debug profile
by Robert Sample » Tue May 17, 2016 8:10 pm
Google is your friend. Googling cics debug profile returned about 37,200 hits and on the first page of results is http://www.ibm.com/support/knowledgecen ... ug0023.htm which has
Starting Debug Tool for CICS programs by using CADP
Before you begin, verify that you prepared your CICS program as instructed in Preparing a CICS program.
To start Debug Tool under CICS by using CADP, do the following steps:
If you chose screen control mode, start the DTSC transaction on the terminal you specified in the Display Id field.
Run your CICS programs. If Debug Tool identifies a task that matches a CADP profile, Debug Tool starts. If you chose screen control mode, press Enter on the terminal running the DTSC transaction to connect to Debug Tool.
Refer to the following topics for more information related to the material discussed in this topic.
Related tasks
Creating and storing debugging profiles with CADP
Related references
CICS Supplied Transactions
- Robert Sample
- Global moderator
- Posts: 3720
- Joined: Sat Dec 19, 2009 8:32 pm
- Location: Dubuque, Iowa, USA
- Has thanked: 1 time
- Been thanked: 279 times
Re: How to execute a debug profile
by tivrfoa » Wed May 18, 2016 3:13 am
with DTSC:
DTSC Debug Tool Screen Control
Terminal T0JH waiting for Debug Tool.
Press Enter to connect or continue waiting.
Press PF3 to Quit.
I press Enter and nothing happens.
There's a CICS command that goes to a screen that I can type something like:
RUN MY_PROFILE
and I can even pass some parameters, but I don't remember. :/
An alternative is to call my program though a Natural program, and then it activates the debug.
But I should not need a Natural program for this.
DTSC Debug Tool Screen Control
Terminal T0JH waiting for Debug Tool.
Press Enter to connect or continue waiting.
Press PF3 to Quit.
I press Enter and nothing happens.
There's a CICS command that goes to a screen that I can type something like:
RUN MY_PROFILE
and I can even pass some parameters, but I don't remember. :/
An alternative is to call my program though a Natural program, and then it activates the debug.
But I should not need a Natural program for this.
Previous topic • Next topic • 4 posts
• Page 1 of 1
-
- Related topics
- Replies
- Views
- Last post
-
- Search/display PROFILE
1, 2by clapclash » Mon Dec 26, 2011 11:23 pm - 13 Replies
- 5197 Views
- Last post by mongan
Wed Dec 28, 2011 1:01 pm
- Search/display PROFILE